Eastman Wash-Off Relief

Subtractive 3 color: dye imbibition process, still photography
“In October 1935 Eastman Kodak Company introduced Eastman Wash-Off Relief. For years the company had been producing matrices and blank films for Technicolor motion pictures, and Kodak engineers were familiar with the requirement of the dye ...

1 Image

Dymat Process

Subtractive 3 color: Dye transfer, Super-8

Fuji Dyecolor

Subtractive 3 color: dye imbibition process, still photography
“Around 1975, Fuji Photo Film Company introduced Fuji Dyecolor, a dye imbibition printing service available only in Japan. A feature of the process was that the transfer of the dyes was done automatically in a special rotary machine developed ...

Technicolor No. III

Subtractive 2 color: Beam-splitter, dye transfer

The third Technicolor process used the same camera as process no. II to combine a pair of frames of the red and green record respectively on the b/w negative (see image). In contrast to the former process, however, the two images were printed on one side of the positive by the dye transfer or imbibition process.

1298 Images in 38 Galleries

Technicolor No. IV: Three-strip

Subtractive 3 color: Color separation, beam-splitter, dye transfer
With the fourth Technicolor process the company dominated the market for color films from the mid-1930s to the 1950s. In a special camera, three b/w negative films were exposed through a beam-splitter that consisted of two prisms to form a cube. One ...

1881 Images in 65 Galleries

Technichrome

Subtractive 2 color: Dye transfer, 2 color bi-pack, 3 color printing

4 Images in 1 Gallery

Technicolor No. V: Dye transfer prints from chromogenic negative

Subtractive 3 color: Dye transfer
With the introduction of the chromogenic Eastmancolor negative/positive process it became possible to shoot with a normal one-strip camera. Three b/w color separations were produced from the Eastmancolor negative and printed by dye transfer on blank ...

2261 Images in 41 Galleries

Chromolithography

Applied colors: printing
Widely used in print media around 1900, the chromolithographic printing process was first adapted for the Laterna Magica and then utilized to produce early animated films primarily aimed at children. These films were usually very short ...

119 Images in 3 Galleries

Traube / Uvachrome

Subtractive 3 color: Mordanting, dye transfer, wash-off relief, still photography
“In the imbibition process, a dye image is transferred from a gelatin relief image to a receiving layer made either of paper or film. Charles Cros described this method of ‘hydrotypie’ transfer printing in 1880 and suggested it ...

3 Images

Autotype Wet Carbon

Subtractive 3 color: pigment process, still photography
“Introduced by the Autotype Company in 1944, the Autotype Wet Carbon Process was a variant of the traditional carbon process with novelty wet-printing pigment papers. Considerable time was saved when printing with this material as the pigment ...

ArchivalColor

Subtractive 4 color: pigment process, still photography
“In the early 1980s photographers frustrated by the poor stability of dye coupling materials started to experiment with pigment processes. Among them was Charles Berger, a California-based fine art photographer who, in 1982, developed a modern ...

2 Images

Hydrotypie / Hydrotype

Subtractive 3 color: Dye transfer, still photography
“In the imbibition process, a dye image is transferred from a gelatin relief image to a receiving layer made either of paper or film. Charles Cros described this method of ‘hydrotypie’ transfer printing in 1880 and suggested it ...

Colorsnap, Colorol

Subtractive 3 color: dye imbibition process, still photography
“In 1929 the London firm Colour Snapshots Limited introduced Colorsnap, a printing service based on the dye imbibition process for a tripack roll film called Colorsnap and manufactured by Ilford Ltd. (Monopolies Commission 1966).11 The tripack ...

1 Image

Defender Pan-Chroma-Relief

Subtractive 3 color: dye imbibition process, still photography
“In 1942 Defender Photo Supply Company of Rochester, New York, introduced a panchromatic matrix film called Pan-Chroma-Relief Film, which simplified the making of dye imbibition prints from original Kodachrome or Ansco Color transparencies.20 ...

Dufaytissue

Subtractive 3 color: pigment process, still photography
“Dufaytissue materials, marketed by Dufay-Chromex Limited of London between 1941 and 1948, resembled Belcolor and were used to produce color prints by contact. After they had been sensitized and dried, the pigment films were exposed by contact ...

1 Image

1 Image

Chromatone

Subtractive 3 color: silver toning, still photography
“Chromatone was the first commercially viable process of color print making entirely based on silver toning. It was developed in the early 1930s by the New Yorkers Francis H. Snyder and Henry W. Rimbach, who patented the toning methods and ...

2 Images

Hicrography / Hicrome

Subtractive 3 color: dye imbibition process, still photography
“In 1915 the company launched a hybrid dye imbibition color printing system called Hicrography.9 From the separation negatives, positive impressions were made through the base on the presensitized dichromated film (Hicro Film), which also ...

1 Image

Jos-Pé

Subtractive 3 color: dye imbibition process, still photography
“Invented by G. Koppmann and introduced in Hamburg in 1924 by the German financier Josef-Peter Welker, from whom the product took its name (Wall and Jordan 1940: 330), Jos-Pé was a complete color system that included a one-exposure camera, ...

1 Image

Belcolor

Subtractive 3 color: pigment process, still photography
“Introduced in the mid-1930s by George Murphy, Inc., of New York City, Belcolor was considered one of the simplest ways to obtain color transparencies, as it required no special equipment or expert technique and could be used successfully ...

Autotype Trichrome Carbro

Subtractive 3 color: pigment process, still photography
“As in previous versions of the process, pigment papers were soaked in a sensitizing bath and then squeegeed firmly onto the surface of wet bromide prints to harden the pigmented gelatin in proportion to the amount of silver contained in the ...

1 Image

Carbro-Chromatone

Subtractive 3 color: pigment process, still photography
“References to Carbro-Chromatone prints are sometimes found in the literature on early color photography. These prints were made using a combination of the two processes they were named after. The method was described by Harlan L. Baumbach in ...

Crawford Flexichrome 1940–1942, after 1949 Kodak Flexichrome

Subtractive 3 color: hybrid dye imbibition process, still photography
“In the 1940s a product called Crawford Flexichrome appeared on the market. It allowed photographers to obtain prints or transparencies in full color by simply applying dyes of various colors by hand to a gelatin relief image.16 Results ...

1 Image

Duxochrome / Colorstil / Duxocolor

Subtractive 3 color: pigment process, still photography
“Duxochrome, introduced around 1930 by the Johannes Herzog Company of Bremen, Germany, combined the colored gelatin layers of pigment processes with the tanning development procedure of dye imbibition. Exposures from three separation negatives ...

1 Image

Pinatype / Pinatypie

Subtractive 3 color: Dye transfer, still photography
“In the imbibition process, a dye image is transferred from a gelatin relief image to a receiving layer made either of paper or film. Charles Cros described this method of “hydrotypie” transfer printing in 1880 and suggested it ...

4 Images

Kwik-Print

Subtractive 3 color: pigment process, still photography
“In 1977 Light Impressions Corporation of Rochester, New York, introduced Kwik-Print, a contact speed color printing material. This was a modification of the Kwik-Proof graphic arts proofing system made by Direct Reproductions Corporation of ...

1 Image

Condax-Dytrol

Subtractive 3 color: dye imbibition process, still photography
“Around 1940, Condax-Speck, Inc., of New York started to market dyes and mordant for the Condax-Dytrol system of dye imbibition printing (Fig. 4.19). The system, developed by company owners Louis M. Condax (1897–1971) and Robert P. Speck, ...

Kodak Dye Transfer

Subtractive 3 color: dye imbibition process, still photography
“Kodak Dye Transfer materials were introduced by Eastman Kodak Company in February 1946 and replaced Eastman Wash-Off Relief. Principal improvements over the previous material included a simplified registration procedure, more rapidly ...

1 Image

Handschiegl / DeMille-Wyckoff / Wyckoff Process

Applied color: Imbibition
Similar to stenciling, the Handschiegl process was applied mechanically to manually defined image parts. Therefore it is an applied color process. After the film was shot and edited, for each color applied a separate print was made. In contrast to ...

141 Images in 8 Galleries

Autotype Dyebro

Subtractive 3 color: dye imbibition process, still photography
“Autotype Dyebro Introduced around the same time as Colorsnap and Uvatype, Autotype Dyebro combined the three-color carbro and dye imbibition processes. The method was invented by Owen Wheeler (1859–1932) and commercialized by the Autotype ...

Russian three-color process

Subtractive three color

6 Images

Fresson Quadrichromy

Subtractive 4 color: pigment process, still photography
“In 1951, when pigment processes were falling into disfavor, Pierre Fresson (1904–1983) of Atelier Fresson developed Fresson Quadrichromy, a four-color printing method based on the monochrome direct carbon process (charbon-satin) that had ...

1 Image

Ataraxia

Subtractive 4 color: pigment process, still photography
“In 1998 Racey Gilbert purchased Polaroid’s stock of pigment films and opened Ataraxia Studio in Bensalem, Pennsylvania, to make high-quality collectors’ carbon prints. Under the direction of Gérard Niemetzky, the studio produced ...

1 Image

Irix-Farbenfilm

Subtractive three-color process: imbibition
Three matrices in the subtractive primary colors are printed on the gelatin of the final print. Supposedly, the used dyes were particularly fast and able to prevent color bleeding. Pokorny started working on color cinematography in the 1920s, often ...

Technicolor No. VI: Dye-transfer prints from enhanced process

Subtractive 3 color: dye transfer
In 1994, Technicolor announced the development of an enhanced dye-transfer process. This process became effective in  June 1997. There was no official denomination, so “Technicolor No. VI” is not to be confused with statements from the mid ...

Curtis Orthotone

Subtractive 3 color: dye imbibition process, still photography
“In 1939 Thomas S. Curtis (1889–1964) proposed Orthotone, a dye imbibition printing method that was primarily a variation of the widely used Eastman Wash-Off Relief. Orthotone offered its practitioners complete control on the contrast or ...

1 Image

EverColor

Subtractive 4 color: pigment process, still photography
“Also during the 1990s, William (Bill) Nordstrom started to experiment with a carbon process called Agfa-Proof, a four-color proprietary prepress color proofing system. He founded the EverColor Corporation in El Dorado Hills, California, in ...

1 Image

Kelleycolor

Subtractive 2 color: Dye transfer
“In 1919 Kelley produced a series of coloured cartoons which were drawn by Pinto Colvig. In 1924 he introduced “Kelleycolor,” which was an imbibition process. Two colours were imbibed on a black-and-white key image. In 1926 he ...

1 Image